SynergyMill

Fits the standard PETG tube nozzle

Connect USB-C devices to a USB-A port with this super convenient adapter. Unsure if USB 3.0 speeds are supported or USB 2.0 only. Trustworthy device with no malware embedded in the housing for sure, I think.

Rechargeable electric Scissors that can cut cloth, plastic sheet, soft material

https://www.samsclub.com/ip/Member-s-Mark-24-Can-Waterproof-Backpack-Cooler/17888307682

https://www.harborfreight.com/25-liter-ultrasonic-cleaner-63256.html

This will need to stay at home but I can print things if you need it!

(Attached to my light truck). If you need to tow something not too heavy, I can help

https://www.amazon.com/dp/B0F1Y41G14

Renogy https://www.amazon.com/dp/B0D3DZWXT4/

OneTigris https://www.amazon.com/dp/B0D4M15VB2

Modified Harbor Freight pressurized paint sprayer. It no longer will spray paint, but hook up your compressor, put your silicone molds filled with two-part urethane inside, batten down the hatches and start the air. Run it to about 60 psi and it should hold it for a few hours so your castings will come out bubble-free.

For adjusting the truss rod/neck relief after frets have been installed. Notches spaced for standard 34" scale length (Fender Precision/Jazz Bass, etc.). To save a few bucks I marked up a heavy aluminum T-square from Harbor Freight with a Sharpie and then attacked it with an angle grinder and sandpaper flap disk. Lives at Casa Del Gamp

This is on the lending shelf at SynergyMill

This is on the lending shelf at SynergyMill

This is on the lending shelf at SynergyMill

29.5 - 147.5 ft lbs